The Anarchist Cookbook (20 page)
by either 7 digits (if the call were in the same NPA as the seized trunk) or 10 digits (if the
call were not in the same NPA as the seized trunk). [Exactly like dialing normal fone call].
Following either the KP and 7 or 10 digits, a STart is sent to signify that no more digits
follow. Example of a complete call:
Dial 1-806-258-1234
Wait for a call-progress indication (such as ring,busy,recording,etc.)
Send 2600Hz for about 1 second.
Wait for about ll-progress indication (such as ring,busy,recording,etc.)
Send KP+305+994+9966+ST
The call will then connect if everything was done properly. Note that if a call to an 806
number were being placed in the same situation, the are code would be omitted and only KP
+ seven digits + ST would be sent. Code 11 and code 12 are used in international calling to
request certain types of operators. KP2 is used in international calling to route a call other
than by way of the normal route, whether for economic or equipment reasons. STp, ST2p,
and ST3p (prime, two prime, and three prime) are used in TSPS signaling to indicate calling
type of call (such as coin-direct dialing.
78. Napalm II by The Jolly Roger
[See file #021 of the Cookbook for an easy way to make it! ]
About the best fire bomb is napalm. It has a thick consistency, like jam and is best for use
on vehicles or buildings. Napalms is simply one part gasoline and one part soap. The soap is
either soap flakes or shredded bar soap. Detergents won't do. The gasoline must be
heated in order for the soap to melt. The usual way is with a double boiler where the top
part has at least a two-quart capacity. The water in the bottom part is brought to a boil
and the double boiler is taken from the stove and carried to where there is no flame. Then
one part, by volume, of gasoline is put in the top part and allowed to heat as much as it will
and the soap is added and the mess is stirred until it thickens. A better way to heat
gasoline is to fill a bathtub with water as hot as you can get it. It will hold its heat longer
and permit a much larger container than will the double boiler.
79. Nitroglycerin Recipe by The Jolly Roger
Like all chemists I must advise you all to take the greatest care and caution when you are
doing this. Even if you have made this stuff before. This first article will give you
information on making nitroglycerin, the basic ingredient in a lot of explosives such as
straight dynamites, and gelatin dynamites.
Making nitroglycerin:
Fill a 75-milliliter beaker to the 13 mL. Level with fuming red nitric acid, of 98% pure
concentration.
Place the beaker in an ice bath and allow to cool below room temp.
After it has cooled, add to it three times the amount of fuming sulferic acid (99% h2so4).
In other words, add to the now-cool fuming nitric acid 39 mL. Of fuming sulferic acid.
When mixing any acids, always do it slowly and carefully to avoid splattering.
When the two are mixed, lower their temp. By adding more ice to the bath, about 10-15øC.
(Use a mercury-operated thermometer)
When the acid solution has cooled to the desired temperature, it is ready for the glycerin.
The glycerin must be added in small amounts using a medicine dropper. (Read this step
about 10 times!) Glycerin is added slowly and carefully (I mean careful!) Until the
entire surface of the acid it covered with it.
This is a dangerous point since the nitration will take place as soon as the glycerin is
added. The nitration will produce heat, so the solution must be kept below 30øC! If the
solution should go above 30øC, immediately dump the solution into the ice bath! This
will insure that it does not go off in your face!
For the first ten minutes of nitration, the mixture should be gently stirred. In a normal
reaction the nitroglycerin will form as a layer on top of the acid solution, while the
sulferic acid will absorb the excess water.
After the nitration has taken place, and the nitroglycerin has formed on the top of the
solution, the entire beaker should be transferred slowly and carefully to another
beaker of water. When this is done the nitroglycerin will settle at the bottom so the
other acids can be drained away.
After removing as much acid as possible without disturbing the nitroglycerin, remove the
nitroglycerin with an eyedropper and place it in a bicarbonate of soda (sodium
bicarbonate in case you didn't know) solution. The sodium is an alkali and will
neutralize much of the acid remaining. This process should be repeated as much as
necessary using blue litmus paper to check for the presence of acid. The remaining
acid only makes the nitroglycerin more unstable than it already is.
Finally! The final step is to remove the nitroglycerin from the bicarbonate. His is done
with and eye- dropper, slowly and carefully. The usual test to see if nitration has been
successful is to place one drop of the nitroglycerin on metal and ignite it. If it is true
nitroglycerin it will burn with a clear blue flame.
** Caution **
Nitro is very sensitive to decomposition, heating dropping, or jarring, and may explode if
left undisturbed and cool.
80. Operation: Fuckup by The Jolly Roger
This is a guide for Anarchists and can be funny for non-believers and 12 and 13 year old
runts, and can be a lexicon of deadly knowledge for True Anarchists... Serious damage is
intended to be dealt here. Do not try this stuff unless you want to do a lot of serious
Anarchy.
[Simulation]
Asshole - 'Listen, you little teenager punk shit, shut the fuck up, or I'll knock you down!'
Anarchist - 'O.K. You can't say I didn't warn you. You don't know my rue power...' (soooo
casually)
Asshole - 'Well, er, what do you mean?
Anarchist - '
asshole doesn't...
[Operation Fuckup]
Get a wheel barrel or two. Fill with gasoline. Get 16 rolls of toilet paper, unroll & drench in
the gasoline. Rip to shreds in gasoline. Get asbestos gloves. Light a flare (to be punk), grab
glob of saturated toilet paper (you can ignite the glob or not). Throw either flaming or
dripping glob into:
Any window (picture is the best)
Front doors
Rough grain siding
Best of all, brick walls
First of all, this bitch is near impossible to get off once dried, and is a terror to people
inside when lit! After this... during the night, get a pickup truck, a few wheel-barrels, and a
dozen friends with shovels. The pickup can be used only for transporting people and
equipment, or doing that, and carting all the dirt. When it gets around 12:00 (after the
loser goes beddie - bye), dig a gargantuan hole in his front yard until about 3:00. You can
either assign three or four of your friends to cart the dirt ten miles away in the pickup-
bed, or bury his front door in 15' of dirt! After that is done, get three or four buckets of
tar, and coat his windows. You can make an added twist by igniting the tar when you are all
done and ready to run! That is if the loser has a house. If he lives inside an apartment
building, you must direct the attack more toward his car, and front door. I usually start
out when he goes to work...I find out what his cheap car looks like, and memorize it for
future abuse...It is always fun to paint his front door (apt.) hot pink with purple polka-dots,
and off-neon colors in diagonal stripes. You can also pound a few hundred or so four
inch nails into his front door (this looks like somebody really doesn't like you from the
inside). Another great is to fill his keyhole with liquid steel so that after the bastard
closes his door - the only way to get back in is to break it down. If you can spare it, leave
him an axe - that is, implanted three inches into, and through the door! Now, this next one
is difficult, but one of the best! Get a piece of wood siding that will more than cover his
front door completely. Nail two by fours on the edges of the siding (all except the bottom)
so you have a barge - like contraption. Make a hole at the top that will be large enough for
a cement slide. Mix about six or seven LARGE bags of QUICK drying cement. Use the
cement slide to fill the antechamber created by the 'barge' that is around his door. Use
more two by fours to brace your little cement-filled barge, and let the little gem dry.
When it is, remove the 'barge' so only a stone monolith remains that covers his door. Use
any remaining cement to make a base around this so he can't just push it over. When I did
this, he called the fire department, and they thought he meant wood, so they brought
axes. I watched with a few dozen or so other tenants, and laughed my damn ass off! This
is only his door! After he parks his car for the night, the fun really begins...I start out by
opening up the car by jamming a very thin, but loack - inside and out! Then proceed to put
orange-juice syrup all over the seats, so after he gets through all the other shit that you
do, he will have the stickiest
seats in the world. You can then get a few Sunday papers, and crack one of the windows
about four inches. Lightly crumple the papers, and continue to completely fill the inside of
his car with the newspapers. A copy of the Sunday New York Times will nicely fill a
Volkswagen! What is also quite amusing is to put his car on cinder blocks, slash his tires at
the top, and fill them with cement! Leave the cinder blocks there so that, after he knocks
the car off of them, he will get about 3 miles to the gallon with those tires, and do 0 to 60
in about two minutes! It is even more hilarious when he doesn't know why the hell why!
Another is to open his hood, and then run a few wires from the sparkplugs to the METAL
body. The sure is one HOT car when it is running! Now, I like to pour two pounds of sugar
down his gas tank. If this doesn't blow every gasket in his engine it will do something
called 'caramelizing his engine'. This is when the extreme heat turns the sugar to caramel,
and you literally must completely take the engine out and apart, and clean each and every
individual part! Well, if this asshole does not get the message, you had better start to get
serious. If this guide was used properly & as it was intended (no, not as kindling for the
fire), this asshole will either move far away, seek professional psychological help, commit
suicide, or all of the above!
81. Stealing calls from payphones by The Jolly Roger
Now to make free local calls, you need a finishing nail. I highly recommend "6D E.G.
FINISH C/H, 2 INCH" nails. These are about 3/32 of an inch in diameter and 2 inches
long (of course). You also need a large size paper clip. By large I mean they are about 2in
long (FOLDED). Then you unfold the paper clip. Unfold it by taking each piece and moving it
out 90ø. When it is done it should look somewhat like this:
/----------\
: :
: :
: :
: :
\-----
Now, on to the neat stuff. What you do, instead of unscrewing the glued-on mouthpiece,
is insert the nail into the center hole of the mouthpiece (where you talk) and push it in
with pressure or just hammer it in by hitting the nail on something. Just DON'T KILL THE
MOUTHPIECE! You could damage it if you insert the nail too far or at some weird
angle. If this happens then the other party won't be able to hear what you say. You now
have a hole in the mouthpiece in which you can easily insert the paper clip. So, take out the
nail and put in the paper clip. Then take the other end of the paper clip and shove it under
the rubber cord protector at the bottom of the handset (you know, the blue guy...). This
should end up looking remotely like...like this:
/----------\ Mouthpiece
: :
Paper clip --> : : /
: /---:---\
: : :
:------------>
====================\---))):
: To earpiece ->
^ ^
\-------------------->
: :
: :
Cord Blue guy
(The paper clip is shoved under the blue guy to make a good connection between the
inside of the mouthpiece and the metal cord.) Now, dial the number of a local number you
wish to call, sayyyy, MCI. If everything goes okay, it should ring and not answer with
the "The Call You Have Made Requires a 20 Cent Deposit" recording. After the other end
answers the phone, remove the paper clip. It's all that simple, see? There are a
couple problems, however. One is, as I mentioned earlier, the mouthpiece not working
after you punch it. If this happens to you, simply move on to the next payphone. The one
you are now on is lost. Another problem is that the touch tones won't work when the
